← All cases

Case 04 · · 6 min read

Phosphogypsum processing: ammonium sulphate, calcium carbonate and rare earths

Phosphogypsum piles up beside every large phosphate-fertilizer plant. The RVP-F project turns it into three saleable products: ammonium sulphate, calcium carbonate (phospho-chalk) and a rare-earth concentrate. Below: where the waste comes from, the chemistry, the stated parameters, and what a pilot needs.

01What phosphogypsum is, and how much has piled up

Phosphogypsum is the by-product of sulphuric-acid digestion of phosphate rock in wet-process phosphoric acid. Its base is calcium sulphate as dihydrate or hemihydrate. Each tonne of P₂O₅ in the acid produces 4.2 to 6.5 tonnes of phosphogypsum, counted as dry dihydrate.

In Russia, 12 plants in 9 regions produce phosphogypsum. The annual addition is estimated at 12.5–15 million tonnes. Stock estimates differ: project materials cite 140–200 million tonnes; the Saint Petersburg Mining University put the 2023 stock near 300 million tonnes. The largest dumps sit at plants in Cherepovets, Voskresensk, Balakovo and Apatity.

Only a small share is used: sources put it at 1 to 4 percent of what is generated. The rest stays in gypsum stacks that cover hundreds of hectares and need constant upkeep. Project materials class phosphogypsum as hazard class IV.

02Why almost none of it is used

On paper, phosphogypsum fits many uses: gypsum binders, a set retarder in cement, a soil amendment. Impurities get in the way. Phosphates, fluorine, strontium and partly digested rock remain in it, and the mix changes from plant to plant and even with depth in one dump.

Logistics is the second obstacle. Builders and farmers need stable moisture, particle size and colour, their own spreading equipment, and a short haul. A chemical plant does not treat those as its job, so the dump grows.

Chemical conversion does the work at the plant itself: the waste becomes products with a known market, and the feedstock does not have to be hauled to a customer.

03Chemistry: ammonium sulphate from phosphogypsum

The process is the known conversion of calcium sulphate with ammonium carbonate: CaSO₄·2H₂O + (NH₄)₂CO₃ → (NH₄)₂SO₄ + CaCO₃ + 2H₂O. Ammonium sulphate stays in solution. Calcium carbonate precipitates and is filtered off.

Ammonium carbonate is made from ammonia and carbon dioxide. Fertilizer plants often have both on one site: CO₂ is a by-gas of ammonia production and is usually vented. Phosphogypsum conversion binds part of that CO₂ in calcium carbonate.

Rare earths concentrate in a separate fraction. In phosphogypsum from Khibiny apatite their average content is about 0.4 percent by mass, and individual samples run from 0.2 to 0.6 percent. Cerium, lanthanum and neodymium dominate.

04The RVP-F reactor: parameters from the developer

RVP-F is a flow reactor with hydrodynamic treatment of the reaction mix. The process is continuous and runs at 20–55 °C. The flowsheet has no high-temperature stage. Ammonia and CO₂ return to the cycle.

The developer reports calcium-sulphate conversion up to 98 percent and a reaction time under 1.5 minutes. In batch schemes of the same reaction, the developer estimates 4–6 hours. The developer states that the products meet GOST.

Temperature
20–55 °C
Conversion
98%
Reaction time
< 1.5 min
Module
60 kt/year

The equipment is made in Russia and the metal intensity is low. A module needs 200–300 m² on an operating chemical plant. The developer obtained the parameters; they will be checked on samples from a specific dump, because every plant’s phosphogypsum is different.

05Three products from one tonne of phosphogypsum

Ammonium sulphate (21–23 percent nitrogen) is a nitrogen-sulphur fertilizer for cereals, oilseeds and other crops that need a lot of sulphur. It is the main product by volume: the developer’s calculation puts a 60 kt/year phosphogypsum module at about 49 kt of ammonium sulphate.

Phospho-chalk is calcium carbonate, about 0.56 tonnes per tonne of feedstock, or about 33.6 kt a year from one module. It is used as a concrete filler and as a lime soil amendment.

The third stream is a rare-earth concentrate with neodymium, lanthanum and cerium. Its yield depends on the rare-earth content of the particular dump and will be set by tests. Neodymium goes into permanent magnets; lanthanum and cerium go into catalysts, optics and polishing compounds.

06The regulatory background: accumulated harm and the owner’s duties

Federal Law No. 446-FZ of 30.12.2021 has been in force since 1 September 2022. It requires owners of large production sites, five years before the end of operation, to prepare a plan for preventing and cleaning up pollution, to obtain a positive state environmental review, and to show that the measures are financed. The law directs environmental payments toward finding and cleaning up objects of accumulated harm.

For a fertilizer producer the gypsum stack becomes a long-term obligation. Processing the dump on site shrinks it and yields products the plant can sell through its own channels.

07What a site trial needs

Trials start with samples. Phosphogypsum is taken from several parts and horizons of the dump, and fresh product from current production is taken separately. The samples are checked for moisture, residual phosphates and fluorine, strontium, and the content and mix of rare earths. Those data set the conversion regime, the calcium-carbonate wash, and the rare-earth recovery scheme.

The second question is reagents. The process needs ammonia and CO₂. If the plant makes ammonia, both reagents are on site and the module fits the existing utilities.

The third question is the products. The plant can sell ammonium sulphate in its fertilizer line. Calcium carbonate and the rare-earth concentrate need a separate buyer or a further step. That is settled before the pilot.

08Project status and the next step

The project is at the stage of a technology model. Scientific support comes from the Mendeleev University of Chemical Technology, the Pryanishnikov Institute of Agrochemistry and Lomonosov Moscow State University.

The next step is trials on phosphogypsum from a specific dump. The module is meant to sit on an operating fertilizer plant, with the dump’s owner. The form of participation is open: engineering, a joint project, or project finance.

Project economics on request: my@ostoya.ru.

FAQ

Can phosphogypsum be processed without high temperatures?
Yes. Conversion with ammonium carbonate runs in water. In the RVP-F reactor the working temperature is 20–55 °C, with no high-temperature stage.
What products does RVP-F make from phosphogypsum?
Ammonium sulphate (a nitrogen-sulphur fertilizer), phospho-chalk (calcium carbonate) and a rare-earth concentrate with neodymium, lanthanum and cerium.
What is phospho-chalk?
Calcium carbonate that precipitates when phosphogypsum is converted. It is used as a concrete filler and as a lime soil amendment.
Where are the project economics?
Project economics on request. Write to my@ostoya.ru.

Read also

Sources

  1. D. V. Suchkov, PhD abstract, Mining University: ~300 Mt of phosphogypsum in Russia in 2023, 12 plants in 9 regions
  2. Vestnik NTR, 2022: 4.2–6.5 t of phosphogypsum per 1 t of P₂O₅, about 1% used, conversion with ammonium carbonate
  3. Problems of phosphogypsum formation and use (doi 10.18411/trnio-10-2021-67)
  4. Tsvetnye Metally: rare earths in Khibiny phosphogypsum, 0.4% on average
  5. UrFU: rare-earth content in phosphogypsum 0.2–0.6%
  6. Federal Law No. 446-FZ of 30.12.2021 (GARANT)

Discuss a similar project

Have a waste stream or a site? We’ll work out the process flowsheet.